Need to feed your ’05-and-up ’Stang with enough fuel for massive horsepower? Well, Lethal Performance has four new complete DivisionX fuel systems to feed 850, 1,000, 1,200, and 1,400 horsepower. Check out the official words after the jump...
With the release of the DivisionX S197 fuel hat and their all new GT500 fuel rails we're excited announce several different return style fuel systems for the GT500 owner in need of more fuel.
These fuel system are designed to help safely support higher hp levels and come with everything needed for a complete installation. So whether you're looking to support 700rwhp or 1400hp we have a kit specifically designed just for you.
One of the major improvements these new systems offer are the single feed line. In the past our systems used a different fuel hat which required the use of a 3-into-1 y-block. That also created the need for more lines and fittings making the system cost more and more difficult to install. The new systems use the DivisionX Gen 3 hat which has a single outlet and single return eliminating the use of an external y-block. In addition to that the new fuel hat incorporates an OEM style connector both on the hat and the wiring harness. The advantages to this are that there's no more wires passed through the hat. Wires passed through the hat and sealed with epoxy have been know to leak fuel. The OEM connector guarantees a leak free setup. In addition the OEM connector makes this a true PLUG-N-PLAY setup between the hat and wire harness that doesn't require any soldering at the hat. Simply plug the connector at the end of the wire harness into the connector on the hat and you're done.
The DivisionX fuel hat is a direct replacement for your stock fuel hat. Simply remove the stock setup and the DivisionX hat drops right in. The DX hat uses the same OEM venturi setup and level sender as the stock pump system did so your fuel level will always read accurately.
Easy to Upgrade- If at any point you grow out of the system you're in and need to step up to the next system to support more hp all you need is the pumps as all of the systems are the same except for the pumps.
DivisionX S197 Dual Pump Return Style Fuel Hat
DivisionX GT500 Fual Rails (Clear or Black)
Aeromotive 10 Micron Fuel Filter
Aeromotive Pro-Series 4 Port 1:1 Boost Reference EFI Fuel Pressure Regulator
(2) Walbro GSS 342 255lph Fuel Pumps
Lethal Performance Dual Relay Wiring Harness
CHM 0-100psi Fuel Pressure Regulator
XRP and Fragola Fuel Fittings
Fragola Push-Lite Fuel Hose
OEM Level Sender
Loom Clamps, Self Tapping Screws and Zip Ties
Vacuum Hose and T- Fitting for Boost Reference
Complete Installation Guide with Diagram
NOTES: 2010+ GT's and GT500's use a different level sender than the 05-09 GT's and 07-09 GT500's.Due to that all 2010+ GT's and GT500's need to re-use their stock level sender with this hat. To properly install your stock level sender use the dropdown menu to add the 2010+ level sender bracket to your order.